If your bobbin does not wind quickly and smoothly when you press on your foot pedal, your bobbin winder might not be fully engaged. This can cause uneven winding. Make sure you push your bobbin pin all the way over or loosen your bobbin wheel completely to engage your bobbin winding mechanism.
Is my bobbin tension too loose?
If the bobbin case doesn’t budge, your bobbin tension is too tight. To tighten your bobbin tension, turn the tiny screw on the bobbin case a smidgen clockwise. To loosen bobbin tension, turn the screw counterclockwise. A quarter turn or less is a good place to start.
What causes bobbin thread to bunch up?
Bobbin Thread Tangling
The bobbin keeps pulling and jamming collecting a lot of thread beneath your fabric. There are several culprits for this ranging from a dull needle, improper threading or tension. The tension in both your upper and bobbin threads need to be even. The bobbin could also be placed incorrectly.
How do you fix a bobbin?
How to Fix Bobbin Thread Bunching and Other Threading Problems
- Thread the Machine Properly. Re-thread the upper part of the sewing machine making sure the thread is passing through every single thread guide on its way to the needle. …
- Change the Needle. …
- Inspect the Bobbin. …
- Clean the Machine.
Why is my bobbin not working?
This usually happens if there is grease and dust build up in the bobbin compartment. It can also occur if the bobbin thread is not attached correctly, the thread has formed a knot or a problem with the bobbin case. Open the bobbin compartment, remove the entire bobbin case and clean up the area around the bobbin.
Why is my sewing machine Birdnesting?
The main source of birdnesting or looping is improperly inserted or threaded bobbin or running the embroidery machine with no bobbin. … A tight bobbin tension, together with highly loose needle thread tension, can cause birdnesting. Flagging occurs when the hoop bounces up and down during sewing.
Why is my sewing machine jamming underneath?
However certain you are that the problem with the machine is most likely due to a huge tangled mess of thread in the bobbin underneath the fabric, the most common reason for the jamming is usually the lack of sufficient tension in the upper thread.
What tension should my sewing machine be on?
The dial settings run from 0 to 9, so 4.5 is generally the ‘default’ position for normal straight-stitch sewing. This should be suitable for most fabrics. If you are doing a zig-zag stitch, or another stitch that has width, then you may find that the bobbin thread is pulled through to the top.