Why does my thread keep bunching up underneath?
A: Looping on the underside, or back of the fabric, means the top tension is too loose compared to the bobbin tension, so the bobbin thread is pulling too much top thread underneath. By tightening the top tension, the loops will stop, but the added tension may cause breakage, especially with sensitive threads.
What tension should my sewing machine be on?
The dial settings run from 0 to 9, so 4.5 is generally the ‘default’ position for normal straight-stitch sewing. This should be suitable for most fabrics. If you are doing a zig-zag stitch, or another stitch that has width, then you may find that the bobbin thread is pulled through to the top.
Why is my sewing machine Birdnesting?
The main source of birdnesting or looping is improperly inserted or threaded bobbin or running the embroidery machine with no bobbin. … A tight bobbin tension, together with highly loose needle thread tension, can cause birdnesting. Flagging occurs when the hoop bounces up and down during sewing.
How do you fix bobbin tension?
To tighten your bobbin tension, turn the tiny screw on the bobbin case a smidgen clockwise. To loosen bobbin tension, turn the screw counterclockwise. A quarter turn or less is a good place to start.
Why does my thread keep jamming?
The tension could be too tight or too loose. Set the tension to the basic thread tension setting or adjust the tension manually. The combination of the needle size, thread size and fabric is incorrect. Be sure to use the correct size needle and thread for the type of fabric that you are sewing.
Why is my fabric bunching up when I sew?
Cause. Tension pucker is caused while sewing with too much tension, thereby causing a stretch in the thread. After sewing, the thread relaxes. As it attempts to recover its original length, it gathers up the seam, causing the pucker, which cannot be immediately seen; and may be noticeable at a later stage.
Why is my top thread getting tangled in the bobbin?
Tangling around the bobbin thread
This is usually caused by improper threading which is visible while sewing, the bobbin keeps pulling and jamming while collecting lots of yarn within the material. One reason is a dull needle and tension.
What tension should Jeans be set at?
Tension is ideal up to 6, but is too high after that and pulls the top stitch into a flat line. Regular thread, bobbin thread view. The bobbin stitches clear up around 6 but don’t improve much after that.