Quick Answer: Why is my sewing machine not catching the bobbin?

If it is not in the correct position, the needle will not go down and pick-up your bobbin thread. Next, make sure your needle is inserted correctly, as far as it will go, with the flat side facing back. … If the timing is out, the needle thread is not meeting the bobbin thread in time to form a stitch.

Why is My Brother sewing machine not picking up bobbin thread?

There could be several things that could cause the machine not to pick up the bobbin thread. The upper thread could be tangled. Remove the thread completely from the machine. The correct size spool cap should be used for the size of the thread spool.

Why is my bobbin not moving?

My Bobbin Moves Slowly Or Gets Stuck

This usually happens if there is grease and dust build up in the bobbin compartment. It can also occur if the bobbin thread is not attached correctly, the thread has formed a knot or a problem with the bobbin case.

Why does my sewing machine keep jamming?

1 5 Reasons Why Your Sewing Machine Keeps Jamming: 1.1 Lack of tension on the upper thread. 1.2 Your machine is clogged at some point or place. 1.3 The needle is deformed or broken.

IT IS INTERESTING:  What are the 7 basic hand stitches?

Why is my bobbin case keeps popping out?

The most common cause of this problem is when the bobbin holder’s finger isn’t placed in the small groove located in the needle plate. The best solution, therefore, is to ensure your bobbin holder finger is perfectly fitted in the needle plate.

What happens if you use the wrong bobbin?

The short answer is YES! Filling a sewing machine bobbin too tightly can make a plastic bobbin bulge or stretch the thread if you are using a metal bobbin. This may be hard to see but can cause all kinds of problems. Plastic bobbins can become compressed in the center causing the bobbin to distort.

Is the bobbin case supposed to move?

THe bobbin will move a bit as you sew but don’t expect it to spin wildly. Seems counterintuitive, but that’s how they do it. Now about “raising the bobbin thread”. It means the bobbin thread needs to come up through the little hole under the presser foot.

How do you get a stuck bobbin out?

Bobbin case is stuck

  1. Turn the sewing machine off.
  2. Make sure your needle is raised to its highest position. …
  3. Remove the presser foot and the presser foot holder.
  4. Remove the needle plate cover.
  5. Use the enclosed disc-shaped screwdriver to loosen the two screws on the needle plates.
  6. Remove the bobbin and then the bobbin case.
Quiltnparty