As the bobbin thread tension is factory-set and wouldn’t usually be adjusted for normal sewing. So we’ll be talking only about the top thread tension since that’s where you’d usually make the adjustments. The dial settings run from 0 to 9, so 4.5 is generally the ‘default’ position for normal straight-stitch sewing.
When should I adjust the tension on my sewing machine?
When lower tension is too loose (or upper tension is too tight), knot is visible on right side (left). When upper tension is too loose (or lower tension is too tight), knot is visible on wrong side (right). Tensions can still need adjustment even if they’re balanced.
What thread tension should I use for cotton?
Cotton requires a moderate tension setting, usually between three and four.
What should the tension be set at on a Brother sewing machine?
The tension dial should be set between 2 to 6. b. When the upper thread is just visible on the back of the fabric, the thred tension is correct.
Why is my thread bunching underneath?
A: Looping on the underside, or back of the fabric, means the top tension is too loose compared to the bobbin tension, so the bobbin thread is pulling too much top thread underneath. By tightening the top tension, the loops will stop, but the added tension may cause breakage, especially with sensitive threads.
What tension should I use for stretchy fabric?
For a stretchy fabric, it would be best if you set the upper tension level between 3-4. This adjustment is also a neutral level of tension setting. Step 5: Now, after you have attached the correct needle, stitch type, and tension setting, it is time to test the final stitch on your fabric.
What tension should I use for thin fabric?
The standard tension setting on most sewing machines is 5, which is ideal for the majority of fabrics, you will need to set it tighter for lightweight fabrics such as silk and chiffon and looser for heavier fabrics such as denim or canvas.
How do you tell if your bobbin tension is off?
The thread should unwind just slightly and the bobbin case should drop an inch or two. If the thread unwinds without resistance and the case slips to the floor, your bobbin tension is too loose. If the bobbin case doesn’t budge, your bobbin tension is too tight.
Why is my bottom stitch not straight?
If your thread is pulled tight on the underside and not forming an even stitch then (counter-intuitively) it’s usually the top thread tension that’s wrong. Sometimes very lightweight fabrics such as sheers can get dragged down into the machine so it’s a good idea to use a straight stitch plate.